Fits Aloka UST 944B 3.5 Ultrasound Biopsy Needle Guide

Product Description

Ultrasound Biopsy Needle Guides for Aloka UST-944B-3.5 Transducer (General Purpose)

1. Type:Single angle, accepts 14-22 Gauge instruments

2. Fits:Aloka UST-944B-3.5,UST-9102U-3.5

3. Features:stainless steel, reusable, easy to clean and sterilize

4. Professional new one from Chinese factory, precision manufacturing

5. Qualified one in excellent working condition

6. Provide 90 days warranty

Other Ultrasound  Biopsy Needle Guides related to Aloka that we can offer:

Before using for the first time, perform needle path verification to verify system and needle guide relations. To avoid any injury to the patient, please observe the following:

1. Refer to system manual for proper procedure.

2. Before verifying, ensure all parts are in good condition.

3. Ensure the needle guide and the needle have been installed correctly.

4. Use a needle suitable for the biopsy and the needle guide.

5. Use proper needle length to reach target area.

6. Carefully insert the needle to avoid bending.

7. Use a straight, new, sterile needle for each verification procedure to help predict the needle's orientation accurately.

8. The guidelines are only used to indicate the expected path of the needle.

9. Do not use the needle guide if the needle does not follow the intended path.

10. The needle used for this needle path verification must not be used for the actual procedure, and needle guide must be

Disinfecting and Sterilizing Needle Guide

a) High-level disinfect or sterilize the needle guide using 2% glutaraldehyde-based solution.

b) The needle guide can be sterilized by using steam (autoclave) at 132-138°C for 15 to 30 minutes.

Cleaning the Needle Guide

a) Remove the needle guide from the transducer after each use. Use a small, soft brush to remove visible contaminants from the surface. Keep parts from drying out until complete cleaning can be accomplished.

b) Soak the needle guide for at least five minutes in a neutral pH, low foaming enzymatic detergent. While immersed, use instrument brush to remove trapped contaminants from surfaces and features. If visible contaminants are not easy to remove, repeat the soaking procedure for another five minutes. Remove the needle guide from cleaning solution and remove any remaining residue with dry wipe. Observe cleaning solution manufacturer’s directions for use and recommendations for concentration.

Storage and Transportation

a)Take care and avoid the crash, drop etc.

b) Please store and transport the device in the following environment:

* Store in non-corrosive gas and well-ventilated room

* Ambient temperature: -35℃〜55℃

* Relative humidity: 15％〜95％(no condensation)

* Atmospheric pressure: 700hPa〜1060hPa